Freight trains in the US are often powered by two or more diesel units, each about 4400 horsepower. Those units are each supposed to burn around 210 US gallons per hour when they're producing full power.
People Also Ask
Today's train locomotives are already quite fuel efficient, especially compared to trucks. In fact, trains can haul one ton of goods an average of more than 480 miles on just a single gallon of fuel, making them 3-4 times more fuel efficient than trucks.
How many gallons of gas does a train hold? An SD40–2 locomotive - a 3,000 HP standard line-haul workhouse of the past used by most North American RR holds 3,200 to 4,000 gallons of fuel. A typical switching locomotice - EMD MP 1500 - a 1,500 HP standard switching locomotive will hold 1,100 to 14,00 gallons of fuel.
For a fuel cost of $0.84 per liter of diesel ($3.17 per gallon) (AAR (2012b)), this results in an average running fuel cost of $185 per locomotive-hour. If actual train and operation data are available, energy models or rail simulators may provide more accurate fuel use values for specific conditions.
COST. If you're hauling goods crosstown or even intrastate, trucking may be the better bargain. It's also a good consideration if your volume doesn't even fill one rail car. However, for longer journeys—especially those over 600 miles—shipping by rail is the far more cost-effective option.
Railroads are roughly four times more fuel efficient than trucks. Shipping freight via rail limits greenhouse gas emissions and increases fuel efficiency, reducing the transportation carbon footprint. In fact, moving freight by rail instead of truck lowers greenhouse gas emissions by 75%.
BNSF Locomotives. We have one of the newest locomotive fleets in the industry. A typical BNSF locomotive will travel up to 4.8 million miles in its lifetime - equal to about 20 trips from the earth to the moon.
Are trains more efficient than cars and planes? If you mean energy efficient, yes, trains are far more energy efficient than cars (because they carry so much more people and freight) and planes (who spend so much energy to get 30K feet into the air.)
1000 miles between refuellings would not be unreasonable for a road locomotive with a 4000 gallon tank averaging 40 mph on a line with a maximum grade of 1%. However I would want refuel before I am running on the bottom third of the tank, so perhaps 700 miles is more realistic.
Loading of coal and water and incidental maintenance takes a steam locomotive about 1 hour. A diesel engine can be fueled from a pump in 10 minutes or so.
Thus, while drivers may have fewer hours for sleep in between successive work periods, they are likely to sleep more often in a single day and to be awake for correspondingly shorter periods. Relay van workers must also sleep in noisy crew-van carriages that shudder and vibrate along with the movement of the train.
Yes, diesel engines are always running in case you didn't know! We don't see any other type of train doing this, but only diesel locomotives leave their engine running always. In case you haven't noticed, diesel trains are never turned off. They are always left running.
Even when switchyard locomotives are not moving trains, their diesel engines are usually kept running. This is done to charge batteries, warm engine fluids and meet other operational needs. This can amount to several thousand hours of idling per locomotive each year.
A train engine requires about a hundred litres of fuel to get it started. So it wouldn't be economical if the engine is stopped and started frequently. This apart, if the engine is stopped, the moving parts' lubrication will also come to a halt.
Many of the lines don't make any money or are operated at a loss. To accommodate the money-losing routes, Amtrak uses profits from its popular lines, such as the Northeast Corridor. Since this is one of the most popular routes, Amtrak can charge higher prices and send those profits to other, less profitable lines.