Most yard-switching and short-haul locomotives are equipped with diesel engines ranging from 600 to 1,800 horsepower; road units commonly have engines ranging from 2,000 to 4,000 horsepower.
People Also Ask
Modern locomotives use electric traction instead of gears as electric traction is much more flexible than gears. Diesel fuels generators from the combustion engine and transform the energy using an alternator, which runs the traction motors.
With high-speed rail, train travel is always faster than driving. In many cases, it's even faster than flying, once you factor in the whole air travel song-and-dance. And if you do need to catch a plane, trains make it easier to get to the airport.
Similarly, a typical train might haul 3,000 tons of freight 500 miles and consume approximately 2,885 gallons of diesel fuel. The efficiency of this freight haul would be calculated as: (3000 tons x 500 miles) / (2,885 gallons) = 520 ton-miles per gallon.
Pulling loaded coal cars? Once the train is rolling, an engine with 110,000 lb tractive effort should be able to maintain 11-12 mph with at least 200 cars-- maybe 300 or more.
The giant two-stroke, turbocharged engine and electrical generator provide the huge amount of power needed to pull heavy loads at high speeds. Cummins' locomotive engine weighs over 24,000 pounds (10,886 kilograms). The generator and electric motors add more mass on top of that.
The average fuel consumed per kilo- meter for all passenger and cargo trains is 7.97 L/ km. This value for local, trafficking, railway track laying and maneuvering trains is 7.92 L/km.
Each motor drives a small gear, which meshes with a larger gear on the axle shaft. This provides the gear reduction that allows the motor to drive the train at speeds of up to 125 mph. Each motor can weigh over 6,600 pounds (3,100 kilograms) and draw more than 700 amps of electrical current.
Thus, while drivers may have fewer hours for sleep in between successive work periods, they are likely to sleep more often in a single day and to be awake for correspondingly shorter periods. Relay van workers must also sleep in noisy crew-van carriages that shudder and vibrate along with the movement of the train.
Train engines generate thousands of horsepower and take an hour or more to warm up before they can start pulling rail cars. This is one reason there is reluctance to turn them off. Also, particularly relevant for a locomotive attached to a train, the brakes on the cars in the train do not work without power.
While the average car engine has about 200 horsepower, locomotive engines typically range from 2,000 to 4,500 horsepower. Train operators rely on diesel power across the full range of rail power applications.
HOW SAFE ARE TRAINS? Trains are statistically much safer than driving. In 2020, the Bureau of Transportation Statistics recorded 40,867 total deaths from travel, including in planes, in cars on highways and on trains.