What are the rules for railroad crossing in Indiana?
shall, before crossing at grade a track of a railroad, stop the vehicle not more than fifty (50) feet and not less than fifteen (15) feet from the nearest rail of the railroad.
People Also Ask
The Indiana law is similar to the Iowa law. In Indiana, public travel cannot be blocked for more than 10 minutes by any train, railroad car, or engine. Indiana Code §8-6-7.5-1.
Look and listen for trains even if the red lights and crossing arms aren't active.Reduce speed when approaching crossings and look both ways.Be sure all tracks are clear before crossing — there may be more than one set. If red lights are flashing or if crossing arms have been lowered, stop: DO NOT CROSS!
Trains can come from either direction. Wait until you can see clearly around the first train in both directions. Never walk around or behind lowered gates at a crossing. Do not cross the tracks until the lights have stopped flashing and it is safe to do so.
Never drive around a lowering gate or ignore signals. After a train passes, wait for gates to fully rise and for all lights to stop flashing before your cross. Never assume that there is only one train coming from a single direction.
Expert-Verified Answer. The appropriate action to take when approaching a railroad crossing that does not have signals to direct traffic is Slow down and be prepared to stop.
What if You Get Stuck? If your vehicle stalls or gets stuck on the tracks, do the following: Get yourself and any other passengers out of the vehicle immediately. If a train is coming, get out immediately and move quickly toward the oncoming train and away from the tracks at a 45-degree angle.
A low-voltage electric current is sent between the two rails via a series of relays like the ones in this photo. When a train approaches, the current runs through the train's metal wheels and axles instead of the relays. This short circuit activates the crossing signal.
If there are no gates, drivers are required to stop and may proceed only when it is safe to do so. Remember, trains always have the right-of-way. Some roads will have lights and a crossbuck above the road on a cantilever. Flashing red lights with gates are used to temporarily close the road when a train is approaching.
If there is more than one track, that sign will be present. After one train has passed, look and listen in case another train is coming from either direction. STOP and YIELD signs at the crossing have the same meaning as they do at other intersections.
If there isn't a stop line the driver must stop no closer than 15 feet and no farther than 50 feet from the closest rail. A passive crossing is one that does not have flashing lights or automatic gates. The crossbuck sign, the white X sign, is a regulatory sign that means Yield.
Stay off the tracks: Train tracks, bridges and yards are private property. Never walk, bike, skateboard or run on or along the tracks; it's illegal and dangerous. Cross only at designated rail crossings. Hold hands: Hold hands with smaller children while at stations and crossings.
A stop line, an X and the letters RR may be painted on the pavement in front of railroad crossings. These markings warn you to be aware of the crossing ahead and to pay particular attention to the possible approach of a train.