Loading Page...

What do pilots say to request taxi?

“Taxi/continue taxing/proceed on Charlie, hold short of Runway Two-Seven.” When authorizing an aircraft to taxi to an assigned takeoff runway, state the departure runway followed by the specific taxi route.



People Also Ask

You start out by writing the instructions down as they are given and then just read them back. With more experience you expect, hear and memorize the information better and it's less of a hassle. Of course, in any case you prepare for the flight beforehand.

MORE DETAILS

It's worth mentioning that the taxiways are marked by signs as well. Almost always pilots use a chart, ie a map which shows the airport from the air. Runways are numbered according to their magnetic bearing (runway 22 is roughly aligned to 220 degrees magnetic for example) while taxiways are lettered.

MORE DETAILS

While tipping for taxi drivers is entirely normal, it certainly isn't a requirement in the UK. Indeed, your passengers should never feel pressured into tipping.

MORE DETAILS

Who gives the pilot permission to land or takeoff from the airport? Air Traffic Controller - This person works in the control tower and talks to pilots by radio. An Air Traffic Controller tells the pilots when and where they can land their planes at the airport.

MORE DETAILS

Only when there's enough space for the aircraft to start taxiing forward is the pushback vehicle uncoupled. From that point on, the pilot steers the aircraft to the runway. This is a challenge—not only because of the wingspan, but also because of the many regulations that have to be observed during taxiing.

MORE DETAILS

Some crews talk a lot with each other, while others remain quiet for much of the flight. If pilots share a lot in common and enjoy discussing mutual topics of interest, an entire multi-day trip can be filled with conversation.

MORE DETAILS

The anemometer, the instrument for measuring speed in aeroplanes. Pilots have to promptly know the speed at which they are moving in the mass of air that surrounds the aeroplane and the anemometer is responsible for measuring it. The anemometer, as it is known today, was designed in 1926 by John Patterson.

MORE DETAILS

In the airlines and in much of corporate aviation, the pilot rarely talks directly to the passengers during flight. In fact, there is a “sterile cockpit” rule that says that there shall be no communication with anyone other than the flight crew and ATC below 10,000 feet indicated altitude.

MORE DETAILS