What is the floor of Class E airspace when designated in conjunction with an airport which has an approved instrument approach procedure?
What is the floor of Class E airspace when designated in conjunction with an airport which has an approved IAP? b. 700 feet AGL.
People Also Ask
Class E airspace consists of all controlled airspace that is not associated with Class A, Class B, Class C, or Class D airspace. This airspace is typically found around airports that do not have an operating control tower or en route airspace above 700 feet AGL or 1,200 feet AGL.
Introduction: Class E airspace is controlled airspace that is designated to serve a variety of terminal or en route purposes. Class Echo airspace is controlled through the Air Route Traffic Control Center (ARTCC)
Class E Airspace: Controlled airspace which is neither class A, B, C nor D. In most areas of the United States, class E airspace extends from 1,200 feet (370 m) above ground level (AGL) up to but not including 18,000 feet (5,500 m) MSL, the lower limit of Class A airspace.
As an FAA-certified remote pilot under the Part 107 regulations, if you need to operate in Class B, C, D, or E airspace, you need to get prior approval to operate in that airspace.
Perhaps the most misunderstood airspace category, Class Echo (E) starts at 14,500'MSL and extends up to but not including 18,000' (bottom of Alpha Airspace) over the entire continental United States unless otherwise depicted. It also exists above Alpha (above 60,000').
E - Shuttle Service (no reservation allowed) or Economy/Coach Discounted. F - First Class. G - Conditional Reservation. H - Economy/Coach Discounted – Usually an upgradable fare to Business. J - Business Class Premium.
Most airspace in the United States is class E. The airspace above FL600 is also class E. No ATC clearance or radio communication is required for VFR flight in class E airspace. VFR visibility and cloud clearance requirements are the same as for class C and D airspaces when below 10,000 feet (3,000 m) MSL.
Class E airspace is often confusing though because it's not clearly depicted on the sectional chart, like the ATC-controlled Classes B, C or D. While Class E airspace is considered “controlled airspace”, you do not need an ATC clearance to fly in it.
The FAA requires ADS-B Out capability in the continental United States, in the ADS-B rule airspace designated by FAR 91.225: Class A, B, and C airspace; Class E airspace at or above 10,000 feet msl, excluding airspace at and below 2,500 feet agl; Within 30 nautical miles of a Class B primary airport (the Mode C veil);
SVFR operations may be authorized for aircraft operating in or transiting a Class B, Class C, Class D, or Class E surface area when the primary airport is reporting VFR but the pilot advises that basic VFR cannot be maintained.