What is the guideline for crossing a railroad track in relation to space on the other side of the tracks?

And, remember, trains are wider than the track. Before you pull onto the track, make sure there is enough room on the other side for the back of your vehicle (and any overhanging cargo) to be at least 6 feet beyond the furthest rail. Look again. Before you move, look again in both directions.



People Also Ask

Look and listen for trains even if the red lights and crossing arms aren't active. Reduce speed when approaching crossings and look both ways. Be sure all tracks are clear before crossing — there may be more than one set. If red lights are flashing or if crossing arms have been lowered, stop: DO NOT CROSS!

MORE DETAILS

The US Standard railroad gauge (distance between the rails) is 4 feet, 8.5 inches.

MORE DETAILS

Trains can come from either direction. Wait until you can see clearly around the first train in both directions. Never walk around or behind lowered gates at a crossing. Do not cross the tracks until the lights have stopped flashing and it is safe to do so.

MORE DETAILS

The US standard railroad gauge is 4 feet, 8.5 inches (Gauge means width between the two rails). The U.S. federal safety standards allow the standard gauge to vary from 4 ft 8 in (1,420 mm) to 4 ft 9 1/2 in (1,460 mm) for operation up to 60 mph (97 km/h).

MORE DETAILS

Railroad tracks, and usually the land extending up to 50 feet on either side, are private property of railroad corporations. Railroad police have interstate jurisdiction and can investigate and enforce all state law crimes against the railroad whether or not the officers are on railroad property.

MORE DETAILS

Flashing red lights, lowered crossing gates and/or a bell at a railroad crossing indicate that you must stop, at least 15 feet (5 m) from the tracks.

MORE DETAILS

Stop at least 15 feet, but not more than 50 feet, from nearest rail.

MORE DETAILS

Stop, look both ways, and listen. Know that trains always have the right of way. Don't stop on the tracks. Make sure you have room to get across.

MORE DETAILS

If there are no gates, drivers are required to stop and may proceed only when it is safe to do so. Remember, trains always have the right-of-way. Some roads will have lights and a crossbuck above the road on a cantilever. Flashing red lights with gates are used to temporarily close the road when a train is approaching.

MORE DETAILS

In North America, equipment for unlimited interchange between railway companies is built to accommodate for a 288-foot (87.8 m) radius, but normally a 410-foot (125.0 m) radius is used as a minimum, as some freight carriages (freight cars) are handled by special agreement between railways that cannot take the sharper ...

MORE DETAILS

What happens if you stand too close to a train? Air between person and the train moves with high velocity due to dragging effect and the air behind person is approximately still.

MORE DETAILS

These gaps which are of the order of a few millimeters, are provided to allow room for the rails to expand the rise in temperature due to the atmospheric temperature as well as the friction caused by running of train. All materials expand when heated and contract when cooled.

MORE DETAILS