Why do planes fly at 35k feet?

Pilots often choose to fly at this level because this is the optimum height for commercial operations. Carriers avoid a massive amount of turbulence that would occur at lower levels. Along with this, most thunderstorms, severe weather incidents and birds can be avoided while above 35,000 feet.



People Also Ask

The biggest reason for flying at higher altitudes lies in fuel efficiency. The thin air creates less drag on the aircraft, which means the plane can use less fuel in order to maintain speed. Less wind resistance, more power, less effort, so to speak.

MORE DETAILS

Turbulence can occur anywhere in the atmosphere, from ground level to near the upper limits of standard high-level en route charts, typically above Flight Level (FL) 350 (approximately 35,000 ft).

MORE DETAILS

When an aircraft experiences turbulence, the plane can drop or change altitude suddenly. This is why pilots always caution passengers to buckle up and stay seated when they are experiencing flight turbulence. The sudden movements put passengers at risk.

MORE DETAILS

Severe turbulence can cause a plane to drop so suddenly that pilots temporarily lose control. But, again, that's not enough to crash the plane. That's not to say it's never happened. In 1966, human error and turbulence combined to bring a plane down over Mount Fuji.

MORE DETAILS

Aerodynamic altitude: If a commercial airliner flies too high, it will encounter less dense air passing over the wings to create lift. This can cause the plane to stall and fall out of control. Depending on the weather conditions and aircraft weight, this can occur anywhere between 40,000 and 45,000 feet.

MORE DETAILS

Whether flying at night or during the day, pilots need to see some kind of horizon. They use this to determine the airplane's attitude. At night pilots will turn their gaze from outside to inside and use the artificial horizon. The artificial horizon is normally a simply globe split into two hemispheres.

MORE DETAILS

Techincally, there is only one way for the aircraft to remain hanging motionless in the air: if weight and lift cancel each other out perfectly, and at the same time thrust and drag cancel each other out too. But this is incredibly rare. To stay in the air and sustain its flight, an aircraft needs to be moving forward.

MORE DETAILS

Most flights are intended to spend as little time as possible over water, since storms are more common over the ocean than on land. An aircraft would not be safe to fly over the Pacific Ocean due to the stormy weather and frequent lightning strikes that occur there.

MORE DETAILS

The term hard landing usually implies that the pilot still has total or partial control over the aircraft, as opposed to an uncontrolled descent into terrain (a crash). Hard landings can vary in their consequences, from mild passenger discomfort to vehicle damage, structural failure, injuries, and/or loss of life.

MORE DETAILS

An overloaded aircraft may not be able to leave the ground, or if it does become airborne, it may exhibit unexpected and unusually poor flight characteristics. If not properly loaded, the initial indication of poor performance usually takes place during takeoff.

MORE DETAILS

Turbulence is a sudden and sometimes violent shift in airflow. Those irregular motions in the atmosphere create air currents that can cause passengers on an airplane to experience annoying bumps during a flight, or it can be severe enough to throw an airplane out of control. (The pilots) aren't scared at all.

MORE DETAILS

At times like this, pilots will slow to a designated “turbulence penetration speed” to ensure high-speed buffet protection (don't ask) and prevent damage to the airframe. We can also request higher or lower altitudes, or ask for a revised routing.

MORE DETAILS

From a practical point, no, a modern airliner will not lose a wing due to turbulence. Modern airlines are very tough and designed to withstand extreme turbulence. In theory, it might be possible. But to my knowledge, it has not happened to any jet airliner.

MORE DETAILS