Can we fly over it? Technically yes, BUT it's still a very bad idea because a motor out would force you to descend through the Class C airspace. We CAN'T fly here without special permission from ATC. Permission should be obtained in advance by telephone (some controllers will accept a radio call).
People Also Ask
To enter Class C airspace, all aircraft must meet the following requirements:
Two-way radio.
Mode-C transponder.
ADS-B Out device.
Establishment of two-way communication with the airspace controller.
As described in 14 CFR 91.225, ADS-B Out performance is required to operate in:Class A, B, and C airspace. Above the ceiling and within the lateral boundaries of a Class B or Class C airspace area upward to 10,000 feet MSL .
The approval needed to enter Class C airspace is like Class D in that you do not need a specific clearance, but you do need to establish two-way communication with control. To be able to enter Class C airspace, a pilot must contact ATC prior to arrival.
Like most controlled airspace, ALL pilots must notify and receive approval from the FAA to fly in Class C airspace. Pilots must also follow the necessary procedure to receive permission. Approval cannot be granted by control towers individually; the request must be sent using one of two methods.
Class C: This is the controlled airspace above 7,500 feet and surrounding major airports. Both IFR and VFR flights are permitted and both require ATC clearance and separation service is to be provided by ATC. Class G: This airspace is uncontrolled.
A Mode C transponder gives air traffic control (ATC) your altitude and an identification code. Specifically, a Mode C transponder is required if you wish to operate in Class A, B, or C airspace, at an altitude of over 10,000' MSL, or within a 30-nautical mile radius of the primary airport in Class B airspace.
There's one more thing to keep in mind when you're operating in Class B airspace: in general, you need to be at least a private pilot to enter the airspace. Student, sport and recreational pilots can enter specific Class B airspaces, but only after they receive training and an endorsement from an instructor.
The purpose of Class C airspace is to enhance aviation safety in the terminal area and to decrease the risk of midair collisions by providing traffic separation service.
The purpose of Class C airspace is to enhance aviation safety in the terminal area and to decrease the risk of midair collisions by providing traffic separation service.
While you don't need an operable transponder to fly below a Class C shelf, you will need one to fly above Class C airspace. As you approach a Class C airport, you'll contact that airspace's approach control. Call ATC on the radio before you're in Class C airspace and make sure to tell them: Your position.
Class B airspace surrounds the busiest airports from the surface to 10,000 feet MSL. The dimensions of Class B airspace vary depending on the needs of the airport. Class C airspace extends from the surface to 4,000 feet MSL.
The Federal Aviation Regulation (FAR) Part 91.119 indicates that, except when necessary for departure or landing, the minimum altitude over urban areas is 1,000 feet above ground level (AGL) and 500 feet AGL over rural areas.
A transponder is not required unless an aircraft is operating: In Class A, Class B, or Class C airspace. Above 10,000 feet Mean Sea Level (MSL), excluding airspace below 2,500 feet Above Ground Level (AGL).
In the 1900s, Hungarian physicist Theodore von Kármán determined the boundary to be around 50 miles up, or roughly 80 kilometers above sea level. Today, though, the Kármán line is set at what NOAA calls “an imaginary boundary” that's 62 miles up, or roughly a hundred kilometers above sea level.
You should advise ATC before any altitude change when operating VFR-on-top. This ensures ATC can provide accurate traffic information and separation. VFR-on-top is not permitted in Class A airspace.
If you are receiving flight following, you are automatically cleared to enter the outer ring of a TFR and to enter Class C or D airspace. However, there is one circumstance that flight following will not protect you from, and that is flying into Class B airspace.
If you are receiving flight following, you are automatically cleared to enter the outer ring of a TFR and to enter Class C or D airspace. However, there is one circumstance that flight following will not protect you from, and that is flying into Class B airspace.